Z-Wave To DALI DT6 & DT8 4 in 1 Controller SR-2411-ZV

The Z-Wave to DALI controller is a Z-Wave device that is used to switch ON/OFF and adjust light intensity of DALI control gears on a DALI circuit and can be controlled by other Z-Wave devices. It can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network. The device cannot act as Z-Wave network controller (primary or secondary), so a security enabled controller is needed for take full advantage of all functionally for the device. It also supports the Over The Air (OTA) feature for the product’s firmware upgrade.

The encryption modes that the Z-Wave to DALI controller supports are S0, S2 Unauthenticated. When the it is being included into a Z-Wave network, you can use your primary controller/gateway to enable one encryption mode or disable encryption. (The primary controller/gateway shall support encryption mode configuration).

Key Features

• 4 in 1 Z-Wave to DALI DT6 & DT8 Controller based on Z-Wave plus
• Receives Z-Wave signal and outputs DALI signal to DALI line, 12-24VDC power supply
• Compatible with universal Z-Wave gateway controllers
• Supports association with Z-Wave remote controls and touch panels
• DALI current consumption less than 4mA
• Controlled DALI device type can be DT6 or DT8, device type selectable by rotary switch
• Controlled DT8 device color type: Tc, XY coordinates, RGBW selectable by rotary switch
• Enable to select Group control or Address control to DALI line by rotary switch
• Enable to control 1 DALI Group of devices or 1 DALI Address on DALI line
• Enable to control all devices on DALI line via broadcast
• Enable to select any DALI Group (0-15) or DALI Address (00-63) to control by rotary switches
• Each DALI line can install multiple controllers for multi control points
• Waterproof grade: IP20